| Item | Value |
|---|---|
| Measured gases | NH3ammonia, CH4methane, C₂H₆O ethanol, COcarbon monoxide, CS2 carbon disulfide, NO nitric oxide, NO2 nitrogen dioxide, H2Shydrogen sulfide, LEL flammable & toxic gases |
| Measuring range | CO 0-1000ppm |
| Detection principle | catalytic combustion |
| Accuracy | |
| Resolution | LED display |
| Response time | <15s |
| Ingress protection | |
| Explosion protection | |
| Operating temperature | -20°C to 50°C |
| Power supply | 12-28 VDC (24V under normal) |
| Output signal | 4-20 mA |
The Insco iTransgas detector uses an intelligent electronic platform to provide single or dual-point detection from a single probe for maximum flexibility, superior performance, and low-cost installation. Optional sensors to be installed: HCl (hydrogen chloride), Cl2 (chlorine), ClO2 (chlorine dioxide), CO (carbon monoxide), CO/H2 Null (no carbon monoxide/hydrogen), H2S (hydrogen sulfide), HCN (hydrogen cyanide), NO2 (nitrogen dioxide), NH3 (ammonia), O2 (oxygen), PH3 (phosphine), SO2 (sulfur dioxide), LEL (lower explosive limit)
■ Fully digital design, strong anti-interference, high stability
■ Single/dual channel setup for flexible options
■ Alloy/stainless steel housing, suitable for harsh environments
■ 4-20 mA and ModBus RTU outputs
carbon monoxide CO 0-1000ppm
Display: Dual-channel high-brightness 4-digit LED display (7 segments per channel).
Operating Voltage: 12-28 VDC (24 VDC in Typical)
Power consumption (max): toxic gas / oxygen: 150 mA, operating voltage 24 VDC (single gas)
flammable gas: 175 mA, 24 VDC operating voltage, 0.6 A peak (single gas)
flammable gas: 150 mA, operating voltage 24 VDC, peak 0.6 A (single gas)
Combined Catalytic/Infrared: 280 mA, 24 VDC (dual gas)
Signal output: 4-20 mA, (linear analog) and ModBus RTU (digital) RS485 digital communication with ModBus RTU software protocol system (9600 baud). Three- or four-wire cable system that can carry more than 200 devices (bus configuration). Address selection via onboard 8-digit digital switch.
Relays: 3 relays: two user-programmable relays (SPST, N.O.), plus a fault relay (SPST, N.C.).
Contact Capacity: 5 A (30 VDC, 250 VAC)
Temperature Range: Normal: -4°F to 122°F (-20°C to 50°C)
Humidity range:
Under Conventional: 15 to 90% RH (non-condensing)
It is suitable for industrial safety monitoring and on-site inspection scenarios.